![]() ![]() This is my APC40 Remix Deck and Step Sequencer Mapping for the Traktor Version 2.11 on Remix Deck C. Before you can use this Mapping you have to put your APC in Ableton Live Alternative Mode by simply Start Ableton Live, connect your APC40 and close Ableton after the coloured rectangle appears in Session View. After this all of the LEDs on the APC40 should be off and you can start Traktor. Just load the tsi file into Traktor and enjoy mixing! If you have any Problems, Questions or Tipps about this mapping feel free to write me a comment or an eMail to [email protected]. Step Sequencer Download1: The top MIDI clip serves as a template for a one-bar, 16th-note, chromatic-scale step sequence. The notes on the left are guide notes for the clip Fold operation. To program your step sequence, select a note, activate it if it is deactivated (grey) and move it with the up and down Arrow keys. Use the Shift key to move notes by octaves. The clips at the bottom illustrate different grids and scales. If you're a fan of step sequencing, Live is more than up to the task. MIDI clips in Session view offer a fully featured approach to step sequencing that requires minimal setup and no additional software or hardware. With not too much effort you can build a basic step sequencer from Live's MIDI Effects devices and use the knobs on any supported MIDI control surface to program it. Max For Live users can download a huge assortment of free step sequencers developed by other users. Furthermore, many commercial hardware and software step sequencers work well with Live. So, as you'll have guessed by now, our subject this month is step sequencing. I'll start with a description of the MIDI clips method, which has become my favourite approach, and then delve into the alternatives. 2: This one-bar, 16th-note step sequence uses velocity and note length to emulate a step sequencer's velocity, gate time and tied note options. The unlinked, four-bar controller lane at the bottom automates a Live Pitch device to transpose successive one-bar repetitions of the step sequence. Any time you enter notes in a MIDI clip with the mouse when Snap to Grid is enabled (Options menu), you are basically step sequencing. But starting with a template MIDI clip containing a note on each grid division and then activating and deactivating notes and moving them up and down to change their pitch is much more in the spirit of hardware and software step sequencers. Screen 1 shows a typical step-sequencing clip template. The sequence is one bar long with a note on each 16th-note division.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |